Last time I had less time to work in My workshop, but I made some new steps in my CNC building.
Two motors already connected and working.
I hope I will run last axis next week, then some chips covers and I machine can cut it own table.
Lucas
Friday, April 5, 2013
CNC - ongoing
Hi,
Last time I had less time to work in My workshop, but I made some new steps in my CNC building.
CNC is now placed on the movable table. And start to set electronic wires to it begin.
Small close up to the concrete foot. It can be seen that concrete filled available places. But it was vibrated almost hour, when it was fresh.
Two motors already connected and working.
I hope I will run last axis next week, then some chips covers and I machine can cut it own table.
Lucas
Last time I had less time to work in My workshop, but I made some new steps in my CNC building.
Two motors already connected and working.
I hope I will run last axis next week, then some chips covers and I machine can cut it own table.
Lucas
Subscribe to:
Post Comments (Atom)
bardzo podobna do mojej maszynki po przeróbkach
ReplyDeleteTwoja maszyna i podobne były natchnieniem, żeby zbudować to cudo.
ReplyDelete